2012 hyundai accent oil capacity




2012 hyundai accent oil capacity

Article Navigation:
  • Photo
  • Oil & Filter Change Hyundai Accent () - Hyundai Accent GLS L 4 Cyl.
  • Video
  • RELATED PAGES
  • Engine, Capacity/Filter, Oil Change Intervals. Accent (USA) ( – ), l US Quarts / Filter: l US Quarts, 9 miles/ 12 months. Accent .

    Hyundai Accent L I4 Engine Oil Change Guide generation (, , , & ) Hyundai Accent in changing the motor oil and replacing the oil.

    Fact about hyundai! The Hyundai logo is not just the letter "H" in the aval. It would be too easy. This emblem symbolizes the handshake of two people - a representative of the concern and a satisfied customer. In addition, in Korean, the word "hyundai" is translated as "modern".

    I purchased a new Accent. Very happy with the I wanted to get everyones opinion on my oil change when rolls around. will.

    2012 hyundai accent oil capacity

    2012 hyundai accent oil capacity

    Drain Oil Set up the workspace, drain oil and replace plug. Remove Oil Cap Take off the oil fill cap. Raise Front of Vehicle. Check for a blown engine fuse Odd electrical problems that come out of nowhere can often signify a blown engine fuse - check and change yours here! Temporarily replace the oil filler cap and push down the oil dipstick.

    2012 hyundai accent oil capacity

    2012 hyundai accent oil capacity

    2012 hyundai accent oil capacity

    2012 hyundai accent oil capacity

    2012 hyundai accent oil capacity

    Warming up the engine to near operating temperature will help suspend any contaminants within the old oil and also allow it to drain out more quickly. Raise the front of the vehicle and securely support it with two jack stands. I prefer to work on one side of the vehicle at a time to keep three wheels on the ground for extra safety. The black metal oil pan is located near the front passenger area of the engine. The oil filter is located just in front of the oil pan.

    Be careful when you remove the oil drain bolt since the old oil may be hot enough to burn your skin depending on how long you allowed the engine to warm up. Loosen the oil drain bolt by turning it counterclockwise with the 17mm socket and ratcheting wrench. If the oil drain bolt is equipped with a crush washer, inspect it and replace it with a new one if necessary.

    2012 hyundai accent oil capacity

    New crush washers can be purchased at your dealership parts counter or at an auto parts store. Spin in the oil drain bolt by hand a few turns in the counterclockwise direction to prevent it from becoming cross threaded.

    Tighten the oil drain bolt by turning it in the clockwise direction with the 17mm socket and ratcheting wrench to just past hand tight or about 30 ft-lbs of torque if you have a torque wrench. Spin off the old oil filter in the counterclockwise direction. If you have trouble turning the old oil filter, you may need to use an oil filter wrench such as the Lisle Lubricating the o-ring on the new oil filter will help it form a better seal, prevent oil leaks and also make it easier to remove during the next oil change.

    2012 hyundai accent oil capacity

    Double check that the oil drain bolt and the new oil filter are tight before moving on to the next steps. Insert an automotive funnel in to the oil filler hole. It is far better to have slightly less oil than necessary in an engine than to have too much. Running an engine that has been overfilled may cause damage to seals, gaskets, or other components. Only pour in about 3 to 3. Start the engine and allow it to run for a few minutes, turn off the engine, and allow the oil to drain back down to the pan for at least 5 to 10 minutes.

    Pull out the yellow handled dipstick, wipe it clean, re-insert it and pull it out again to check the oil level. If necessary, slow in pour in more oil and repeatedly check the level on the dipstick until it reaches just at or below the upper metal dot on the dipstick that indicates the "Full" or "Maximum" line.

    You may not need to pour in the entire 3. Once the oil is at the correct level, replace the dipstick and tighten the oil filler cap in the clockwise direction.

    2012 hyundai accent oil capacity

    Be sure to record the oil change in your vehicle's service records. It would be a good idea to check your parking spot, garage or driveway for drops of fresh oil which may indicate a leak from the drain bolt or the new filter. If you found this guide to be helpful, please consider making a small donation by clicking on the PayPal. I am not a registered charity. Donations are not tax deductible.

    Please help support this website by shopping at Amazon. Twist Off Oil Filler Cap. Pull Up Oil Dipstick. A few compatible replacement oil filters with their part numbers are as follows: Raise Front of Vehicle. Black Metal Oil Pan. Oil Drain Bolt Location. The first steps are to warm up the engine for a few minutes, park the vehicle on a level surface and then turn off the engine. Used Oil Catch Basin. Loosen 17mm Oil Drain Bolt. Slide the used oil catch container to just below the oil drain bolt.

    2010-2016 Hyundai Elantra Oil Change How-To Tutorial



    • Подписаться по RSSRSS
    • Поделиться VkontakteVkontakte
    • Поделиться на FacebookFacebook
    • Твитнуть!Twitter

    Leave a Reply

    Return to Top ▲TOP ▲